TROUBLESHOOTING

CLICK HERE TO GO TO THE "PREPARING YOUR VEHICLE" SECTION

CLICK HERE TO GO TO THE "WIRING THE SEQUENTIAL MODULE" SECTION

CONDITION

CURE

Third (outtermost) lights don't light up
  • Incorrect turn signal flasher. Be sure to replace the flasher as outlined in "preparing the vehicle"
  • Sequential module requires tuning. See "tuning the module"
  • Bulbs burned out. Be sure all bulbs are OK.
Lights sequence out fine when the signal light is on but the outer bulbs don't come on when the hazard lights are on, or the outer lights flash too quickly
Sequential module "buzzes" or lights don't sequence at all. Only the innermost lights come on
  • Bad ground to the sequential module. Be sure the black wire coming from the module is connected to a good, reliable chassis ground.
Lights sequence out at uneven intervals, or they sequence out too fast or too slow
Any or all lights don't light up
  • Incorrect wiring. Check LED lights on flasher. If the LED lights are coming on the vehicle lights should come on as well. Check your wiring.
  • Bad bulb. Check bulbs.
  • Module requires tuning. This condition would cause the outtermost lights to not light up. See "Tuning the module"
Any other problems